Other
TAZICEF®
brand of
ceftazidime for injection, USP PRESCRIBING INFORMATION
PHARMACY BULK PACKAGE – |
Rx only
To reduce the development of drug-resistant bacteria and maintain the effectiveness of Tazicef (ceftazidime) and other antibacterial drugs, Tazicef (ceftazidime) should be used only to treat or prevent infections that are proven or strongly suspected to be caused by bacteria.
Susceptibility Test Methods
When available, the clinical microbiology laboratory should provide the results of in vitro susceptibility test results for antimicrobial drug products used in resident hospitals to the physician as periodic reports that describe the susceptibility profile of nosocomial and community-acquired pathogens. These reports should aid the physician in selecting an antibacterial drug product for treatment.
Dilution techniques
Quantitative methods are used to determine antimicrobial minimal inhibitory concentrations (MICs). These MICs provide estimates of the susceptibility of bacteria to antimicrobial compounds. The MICs should be determined using a standardized test method1,2. The MIC values should be interpreted according to criteria provided in Table 3.
Diffusion techniques
Quantitative methods that require measurement of zone diameters also provide reproducible estimates of the susceptibility of bacteria to antimicrobial compounds. The zone size provides an estimate of the susceptibility of bacteria to antimicrobial compounds. The zone size should be determined using a standardized test method2,3. This procedure uses paper disks impregnated with 30 mcg ceftazidime to test the susceptibility of microorganisms to ceftazidime. The disk diffusion interpretive criteria are provided in Table 3.
| § Susceptibility interpretive criteria for Enterobacteriaceae are based on a dose of 1 gram q8h. For isolates with intermediate susceptibility, use a dose of 2 grams every 8 hours in patients with normal renal function. * For P. aeruginosa, susceptibility interpretive criteria are based on a dose of 2 grams IV every 8 hours in patients with normal renal function. a The current absence of data on resistant isolates precludes defining any category other than 'Susceptible'. If isolates yield MIC results other than susceptible, they should be submitted to a reference laboratory for additional testing. Susceptibility of staphylococci to ceftazidime may be deduced from testing only penicillin and either cefoxitin or oxacillin. | ||||||
Pathogen | Minimum Inhibitory Concentrations (mcg/ml) | Disk Diffusion Zone Diameters (mm) | ||||
(S) | (I) | (R) | (S) | (I) | (R) | |
Enterobacteriaceae§ | ≤4 | 8 | ≥16 | ≥21 | 18 to 20 | ≤17 |
Haemophilus influenzaea | ≤2 | - | - | ≥26 | - | - |
Pseudomonas aeruginosa* | ≤8 | - | ≥16 | ≥18 | - | ≤17 |
A report of "Susceptible" indicates that the antimicrobial drug is likely to inhibit growth of the microorganism if the antimicrobial drug reaches the concentration usually achievable at the site of infection. A report of "Intermediate" indicates that the result should be considered equivocal, and if the microorganism is not fully susceptible to alternative, clinically feasible drugs, the test should be repeated. This category implies possible clinical applicability in body sites where the drug is physiologically concentrated or in situations where a high dosage of drug can be used. This category also provides a buffer zone that prevents small uncontrolled technical factors from causing major discrepancies in interpretation. A report of "Resistant" indicates that the antimicrobial is not likely to inhibit growth of the microorganism if the antimicrobial drug reaches the concentration usually achievable at the site of infection; other therapy should be selected.
Quality Control
Standardized susceptibility test procedures require the use of laboratory controls to monitor and ensure the accuracy and precision of supplies and reagents used in the assay, and the techniques of the individual performing the test1,2,3,4. Standard ceftazidime powder should provide the following range of MIC values noted in Table 4. For the diffusion technique using the 30 mcg disk, the criteria in Table 4 should be achieved.
QC Strain | Minimum Inhibitory Concentrations (mcg/mL) | Disk Diffusion Zone diameters (mm) |
Escherichia coli ATCC 25922 | 0.06 to 0.5 | 25 to 32 |
Staphylococcus aureus ATCC 25923 | --------- | 16 to 20 |
Staphylococcus aureus ATCC 29213 | 4 to 16 | --------- |
Haemophilus influenzae ATCC 49247 | 0.12 to 1 | 27 to 35 |
Neisseria gonorrhoeae ATCC 49226 | 0.03 to 0.12 | 35 to 43 |
Pseudomonas aeruginosa ATCC 27853 | 1 to 4 | 22 to 29 |