Humulin
Product Images NDC 50090-0444

Product Visual Gallery

This gallery contains 43 technical images submitted to the FDA as part of the official labeling for Humulin (NDC 50090-0444). Unlike standard consumer photos, these assets often include clinical data figures, molecular chemical structures, and official manufacturer packaging layouts.

As provided by A-s Medication Solutions, these visuals offer a comprehensive scientific overview of the product's physical and chemical identity, aiding pharmacists and researchers in product verification and study.

FDA Label Image

Figure (Humulin 7030 Pen Ifu 1 V2)

An instructional diagram showing a pen needle cap and syringe cap, with an arrow pointing left, indicating the direction to remove the needle cap from the syringe.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 10 V2)

The image shows a close-up of a cartridge or pen label with the brand name Lilly. The label includes a dosage scale indicating units from 0 to 70. The product is identified as Humulin 70/30 by A-S Medication Solutions, consistent with the insulin formulation typically marked by Lilly branding.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 11 V2)

An instructional illustration showing a hand holding a Humulin 70/30 insulin syringe. The image highlights the plunger being pulled back with a red arrow, indicating the adjustment of the dosage setting on the syringe. The syringe barrel is marked with visible dosage increments and the Lilly logo.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 12 V2)

An instructional diagram showing a close-up of a Humulin 70/30 insulin syringe with the dosage scale visible. A red arrow points to the dosage marking between 11 and 12 units on the syringe barrel, indicating how to read or measure insulin doses.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 13 V2)

An instructional illustration showing a close-up view of an insulin pen dose selector window with the dial set between doses 24 and 26. The red arrow points toward the dial indicating dose adjustment steps.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 15 V2)

An instructional illustration showing a hand injecting Humulin 70/30 insulin into the abdomen. The image emphasizes proper technique for subcutaneous injection in the abdominal area.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 16 V2)

An instructional timer illustration showing a circular timer set for 5 seconds, used to indicate a timing step in medication preparation or administration procedures.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 18 V2)

Illustration showing a close-up view of a Humulin 70/30 insulin syringe or cartridge, focusing on the dose setting dial with the 'Lilly' brand visible and numerical dose markings. The image highlights the dosing mechanism of the insulin delivery device.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 19 V2)

An instructional diagram showing a hand holding a Humulin 70/30 insulin pen with the cap being removed. The illustration demonstrates how to pull off the pen cap prior to use.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 2 V2)

An instructional illustration showing a hand holding a Humulin 70/30 insulin cartridge with a red arrow indicating a back-and-forth motion, likely demonstrating how to mix or shake the insulin before use.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 20 V2)

An instructional illustration showing a hand holding a syringe, with the plunger partially depressed. The syringe barrel displays volume markings from 0 to 180 units, and the needle is capped with a red protective cover. This image likely demonstrates syringe preparation or use technique.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 22 V1)

An instructional illustration showing the removal of the protective cap from a Humulin 70/30 insulin pen. The image depicts the pen with a red arrow indicating the cap being pulled off before use, with the label visible on the pen body.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 3 V2)

An instructional illustration showing a hand holding a Humulin 70/30 insulin syringe and demonstrating the motion for rotating or gently rolling the syringe between the hands. This is typically done to mix the insulin suspension before injection.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 4 V2)

An instructional illustration showing a hand twisting and removing the cap from a vial or container. A red arrow indicates the direction to rotate the cap counterclockwise for removal. This diagram demonstrates how to open the vial, likely related to Humulin 70/30 insulin.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 5 V2)

An instructional illustration showing a syringe with a needle cap being twisted off by rotating the cap counterclockwise. The red arrows indicate the direction to turn for removal.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 6 V3)

An instructional illustration showing how to handle needle shields for a Humulin 70/30 injection product. It depicts an outer needle shield with a red arrow indicating to keep it, and an inner needle shield with the instruction to throw it away.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 7 V2)

An instructional illustration showing a close-up view of a syringe with the Lilly brand name visible on the barrel. The image highlights the syringe's dose measurement markings and includes an upward red arrow indicating a step in the usage process, likely related to drawing or setting the dose.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 8 V2)

An illustration showing a hand holding a syringe vertically with the other hand tapping the side of the syringe barrel. The image appears to depict the preparation or mixing step before an injection, likely related to Humulin 70/30 insulin injection.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu 9 V2)

An instructional diagram showing a hand holding a Humulin 70/30 insulin pen, with a zoomed-in view illustrating the correct alignment of dose indicators on the pen. An arrow below indicates the direction to push or activate the pen, likely demonstrating dose setting or injection technique.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu Parts V3)

Diagram illustrating the parts of the Humulin 70/30 KwikPen and pen needle. The KwikPen parts labeled include the pen cap with cap clip, cartridge holder, rubber seal, plunger, pen body with label, dose indicator, dose window, and dose knob. The separate pen needle parts (needles not included) are outer needle shield, inner needle shield, needle, and paper tab. The dose knob is shown separately as a round, brown component.*

FDA Label Image

Figure (Humulin 7030 Pen Ifu Pen Qr)

FDA Label Image

Figure (Humulin 7030 Pen Ifu Pen V3)

Humulin 70/30 KwikPen by A-S Medication Solutions. The label shows the proprietary name with 70% human insulin isophane suspension and 30% human insulin injection, 0.7 mL unit, intended for single-patient use only. The pen device is a prefilled injectable pen. Manufacturer is referenced as Lilly with a logo.*

FDA Label Image

Figure 1 (Humulin 7030 Pi 1 V1)

A line graph comparing glucose infusion rate (mg/min/kg) over 24 hours between Humulin R U-100 (0.3 U/kg) and Humulin 70/30 (0.3 U/kg). The graph shows glucose infusion rate on the vertical axis and time in hours on the horizontal axis, with Humulin R U-100 peaking higher and earlier than Humulin 70/30.*

FDA Label Image

Figure (Humulin7030 Pen Ifu 14 V1)

An instructional anatomical diagram showing common injection sites on a simplified human figure from front and back views. Highlighted areas include the abdomen, outer thighs, and upper buttocks, indicating typical locations for subcutaneous injections.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 1 V1)

An illustration diagram of a vial labeled to show the protective cap at the top and the rubber stopper located underneath the cap. The vial is displayed in a simple line drawing style without any additional text or branding.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 10 V1)

An instructional diagram showing a hand holding a vial inverted with a syringe needle inserted into it, drawing liquid. A close-up of the syringe barrel is shown to the right with volume markings from 10 to 40 units. The image demonstrates how to draw medication from a vial into a syringe.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 11 V1)

An instructional illustration showing a person drawing liquid medication into a syringe from a vial. The image depicts the hands positioning the vial upside down and pulling back the syringe plunger to draw the fluid.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 12 V1)

An instructional illustration showing a hand holding a vial and drawing liquid into a syringe, indicating to pull the plunger upward to fill the syringe. A close-up image of the syringe barrel shows measurement markings from 0 to 40 units.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 13 V1)

An instructional illustration depicting a hand holding a syringe with the needle pointing upward and an arrow indicating the removal of air bubbles by tapping or pushing the syringe before injection. The other hand is holding a vial, suggesting preparation of a dose from it.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 14 V1)

An illustration showing front and back views of a human figure with shaded areas indicating possible insulin injection sites. Front view highlights the abdomen and front thigh areas, and back view highlights the upper arms and buttocks. This diagram is typically used to guide injection locations for Humulin 70/30 insulin.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 15 V1)

An instructional illustration showing a person administering an injection into the abdominal area. The image depicts the hand holding a syringe inserted into the skin near the waistline, demonstrating proper injection technique.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 16 V1)

An instructional illustration showing a person injecting medication into the abdomen using a syringe. The image focuses on hand positioning and injection site near the navel.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 17 V1)

An instructional illustration showing a person holding a syringe and injecting medication into the upper arm. The image demonstrates the injection technique with the needle angled into the skin.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 2 V1)

An illustration depicting a biohazard sharps container, a vial labeled Humulin, two alcohol prep swabs, and an insulin syringe with a needle. The image appears instructional, representing components for insulin injection preparation and disposal.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 3 V1)

An instructional illustration showing two hands holding a vial, with a double-headed arrow indicating the motion to gently roll the vial between the hands, suggesting how to properly mix or prepare the medication.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 4 V1)

An illustration showing a hand holding a small vial, demonstrating a gentle rocking motion indicated by curved arrows above and below the vial. This likely represents how to properly mix the contents of the vial before use.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 5 V1)

An instructional illustration showing a person using their hands to remove the cap from a vial. One hand holds the vial upright while the other hand lifts the cap off with a twisting motion indicated by an arrow.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 6 V1)

An instructional illustration showing hands preparing a vial for use. One hand holds the vial while the other hand removes or replaces the vial's cap, demonstrating proper handling technique.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 7 V1)

Illustration depicting how to fill a syringe with medication from a vial. The image shows a hand holding a syringe inserted into a vial and another hand pulling down on the syringe plunger to draw up the liquid. A close-up of the syringe barrel displays volume markings from 0 to 40 units.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 8 V1)

An instructional illustration showing hands preparing a syringe with a vial. The image indicates inserting the needle into the vial to draw medication, with an arrow emphasizing the action direction. It is a preparation step for injection, typical for products like Humulin 70/30 insulin.*

FDA Label Image

Figure (Humulin7030 Vial Ifu 9 V1)

An instructional illustration showing a person holding a syringe and drawing liquid from a vial. One hand secures the vial while the other pulls the syringe plunger to extract the medication.*

FDA Label Image

Figure (Humulin7030 Vial Ifu Qr V1)

FDA Label Image

Label Image (Lbl500900444)

The label for Humulin 70/30 by A-S Medication Solutions displays the product number 3467-0 and specifies a concentration of 100 units per mL. It instructs to refrigerate and not to freeze this 10 mL vial. The label also provides distributor details including location in Indianapolis, IN, and a NDC code 0002-6750-01.*

* About these descriptions: Image descriptions on this page are generated by automated AI analysis of the product label images from the manufacturer's FDA label submission (SPL). They are provided for reference only and may contain errors or omissions. Always rely on the printed label itself and the official FDA labeling, and consult a pharmacist or healthcare professional with any questions about this product.