1. Home
  2. Labeler Index
  3. Medline Industries, Lp
  4. 53329-497
  5. Label Information: Medline Nasal Antiseptic Swabs

FDA Label for Medline Nasal Antiseptic Swabs

View Indications, Usage & Precautions

Table of Contents

    1. OTHER
    2. ACTIVE INGREDIENT
    3. PURPOSE
    4. USES
    5. WARNINGS
    6. DO NOT USE
    7. ASK A DOCTOR BEFORE USE IF INJURIES ARE
    8. STOP USE AND ASK A DOCTOR IF
    9. OTC - KEEP OUT OF REACH OF CHILDREN
    10. STORAGE AND HANDLING
    11. DIRECTIONS
    12. OTHER INFORMATION
    13. INACTIVE INGREDIENTS
    14. PRINCIPAL DISPLAY PANEL - SWABSTICK PACKET

Medline Nasal Antiseptic Swabs Product Label

The following document was submitted to the FDA by the labeler of this product Medline Industries, Lp. The document includes published materials associated whith this product with the essential scientific information about this product as well as other prescribing information. Product labels may durg indications and usage, generic names, contraindications, active ingredients, strength dosage, routes of administration, appearance, warnings, inactive ingredients, etc.

Other



Drug Facts


Active Ingredient



Povidone-iodine USP 10%


Purpose



Antiseptic


Uses



  • antiseptic skin preparation
  • helps reduce bacteria that can potentially cause skin infections

Warnings



For external use only


Do Not Use



  • if allergic to iodine
  • in the eyes
  • on children less than 3 years old

Ask A Doctor Before Use If Injuries Are



  • deep or puncture wounds
  • serious burns

Stop Use And Ask A Doctor If



  • redness, irritation, swelling or pain persists or increases
  • infection occurs

Otc - Keep Out Of Reach Of Children



Keep out of reach of children. In case of accidental ingestion, seek professional assistance or consult a poison control center immediately.


Storage And Handling



Avoid excessive heat. Store at room temperature.


Directions



NASAL APPLICATION:

Figure - clorox 01

Figure - clorox 01

  • Use a tissue to clean the inside of both nostrils, including the inside tip of nostril. Discard.

  • Insert swab comfortably into one nostril and rotate for 30 seconds, covering all surfaces. Discard swabstick.

  • Using a 2nd swab, repeat step 2 with the other nostril.

  • Repeat the application in both nostrils, using the 3rd and 4th swabs.

  • Do not blow nose. If solution drips, gently wipe with a tissue.

Other Information



  • 1% titratable iodine
  • not made with natural rubber latex
  • for hospital or professional use only

Inactive Ingredients



disodium phosphate, glycerin, hydroxyethylcellulose, nonoxynol-10, simethicone, water


* Please review the disclaimer below.