PHARMACIST — DETACH HERE AND GIVE INSTRUCTIONS TO PATIENT
Flunisolide Nasal Solution USP, 0.025%
– HOW TO USE YOUR NASAL PUMP UNIT –
Your nasal spray unit with the pump requires no assembly. Just follow the simple instructions below.
IMPORTANT INFORMATION ON FLUNISOLIDE NASAL SOLUTION:
1. You should use flunisolide nasal solution at regular intervals since its effectiveness depends on its regular use (see below).
2. It may take 1-2 weeks before full relief is obtained.
3. You should contact your physician if symptoms do not improve, if the condition worsens, or if sneezing, nasal irritation, or bleeding occurs.
4. You should contact your physician if you know you have been exposed to chickenpox or measles.
To Prime Nasal Pump Unit (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 02) | Parts Of Nasal Spray Unit With The Preassembled Pump. (E83c85f9 89c0 42af A855 E27d08b56d16 03) |
TO PRIME:
1. Remove the dust cover. Put two fingers on “shoulders” of pump unit, and place thumb on bottom of bottle. Push bottle with thumb FIRMLY and QUICKLY 5-6 times or until a fine spray appears. Now your pump is primed. You must prime the pump unit again if you have not used it for 5 days or more, or if you have disassembled it for cleaning.
2. If the solution is delivered in a stream of liquid, it may fail to provide maximum benefit and cause some discomfort. A fine mist can be produced only by a rapid and firm pumping action.
3. Once your pump is primed, it‘s ready to use.
NOTE: Keep dust cover on the pump unit when not in use.
PHARMACIST — DETACH HERE AND GIVE INSTRUCTIONS TO PATIENT
TO USE:
1. Gently blow nose to clear nostrils. If nose is blocked, use medicine your doctor has recommended to open nasal passages.
Gently Blow Nose To Clear (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 04)
2. Remove the dust cover. Be sure the pump unit is primed.
Remove The Dust Cover (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 05)
3. Place the spray tip into one nostril (tip should not reach far into nose).
Place The Spray Tip Into One Nostril (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 06)
Bend head forward so spray will aim toward the back of the nose.
4. Hold pump as shown, resting back of index finger against upper lip.
BE CAREFUL THAT FINGERS DO NOT SLIP OFF THE PUMP AS YOU SPRAY.
5. Point the tip toward the BACK and OUTER SIDE of the nose. Close other nostril with finger. Pump the spray by pushing bottle with thumb FIRMLY and QUICKLY and sniff gently at the same time. Your doctor will tell you whether to pump once or twice in each nostril.
Hold Pump As Shown (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 07)
6. After spraying in nostril, remove unit from nose and bend head back for a few seconds to let spray spread over back of nose.
After Spraying In Nostril, Remove Unit From Nose And Bend Head Back For A Few Seconds (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 08)
7. Repeat Steps 5 and 6 in other nostril. You may feel brief burning or stinging after using the spray.
8. Keep dust cover on the pump unit when not in use.
Keep Dust Cover On The Pump Unit When Not In Use (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 09)
TO CLEAN:
1. If spray nozzle becomes clogged, DO NOT ATTEMPT TO CLEAR IT USING A POINTED OBJECT. Remove the pump unit from bottle.
Remove Pump Unit From Bottle (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 10)
2. Soak only the pump unit in warm water. Squirt several times while holding under water.
Soak Only The Pump Unit In Warm Water. Squirt Several Times While Under Water. (illustrated Direction) (E83c85f9 89c0 42af A855 E27d08b56d16 11)
3. Make sure the pump unit is dry. Assemble as before with 5 or 6 sprays before use.
Bausch & Lomb Incorporated
Tampa, FL 33637
©Bausch & Lomb Incorporated
Revised January 2008
9116400