FDA Label for Procure Products Hand Sanitizing Wipes

Active Ingredient

Alcohol 70% by Volume

Purpose

Antiseptic

Uses

• Antiseptic
• For handwashing to decrease bacteria on the skin, after assisting ill persons, and before contact with a person under medical care treatment
• Apply topically to the skin to help prevent cross contamination
• Recommended for repeated use
• Dries in seconds

Warnings

• Flammable, keep away from fire or flame'
• For external use only

Do Not Use

in or contact the eyes

Discontinue Use If

irritation and redness develops. If condition persists for more than 72 hours, cosult a physician.

Keep This Out Of Reach Of Children

unless under adult supervision. If swallowed, get medical help or contact a Poison Control Center immediately.

Directions

• To start feed: Remove Cover and discard seal from container. From center of toweled roll, pull up wipe corner, tear of first wipe for use. Twist next wipe into a point and thread through the hole in the container cover. Pull through about one inch. Replace cover. Pull wipes as needed and snap off at a 90 ^° angle. Keep cap closed to prevent evaporation.
  • Wipe hands, fingers, interdigital areas and wrists throughly with towelette, Be sure to utilize the entire wipe surface. Allow to dry.
    • If hands are visibly soiled or contaminated, use first wipe to clean hands then discard wipe. Sanitize with a second wipe.
    • Discard after single use.

    
    

Other Information

Lot Number and Expiration Date can be found on container

Inactive Ingredients

Aqua, Propylene Glycol, Glycerin, Tocopheryl Acetate, Aloe Barbadensis Leaf Juice.

Principal Display Panel

NDC: 55681-135-01

Label - 01