Instructions for Use
ARMLUPEG® (arm loo peg)
(pegfilgrastim-unne)
injection, for subcutaneous use
Single-Dose Prefilled Syringe
Guide to parts
Ifu-figue-1 (25659536 Dc3c 46cd 9156 C462149428da 02)
Ifu-figure-2 (25659536 Dc3c 46cd 9156 C462149428da 03)
Important: The needle is covered by the gray needle cap before use.
Important
Read the Patient Information for important information you need to know about Armlupeg before using these Instructions for Use.
Before you use an Armlupeg prefilled syringe, read this important information.
Storing the prefilled syringe
Store Armlupeg in the refrigerator between 36°F to 46° F (2°C to 8°C).
Do not freeze. If Armlupeg is accidentally frozen, allow the prefilled syringe to thaw in the refrigerator before injecting.
Do not use an Armlupeg prefilled syringe that has been frozen more than 1 time. Throw it away and use a new Armlupeg prefilled syringe.
Keep the prefilled syringe in the original carton to protect from light or physical damage.
Take the prefilled syringe out of the refrigerator 30 minutes before use and allow it to reach room temperature, 68°F to 77°F (20°C to 25°C), before preparing an injection.
Throw away (dispose of) any Armlupeg that has been left at room temperature, 68°F to 77°F (20°C to 25°C), for more than 48 hours.
Keep Armlupeg and all medicines out of the reach of children.
Using the prefilled syringe
It is important that you do not try to give the injection unless you or your caregiver has received training from your healthcare provider.
Make sure the name Armlupeg appears on the carton and prefilled syringe label.
Check the carton and prefilled syringe label to make sure the dose strength is 6 mg.
You should not inject a dose of Armlupeg to children weighing less than 99 pounds (45 kg) from an Armlupeg prefilled syringe.
Do not use a prefilled syringe after the expiration date on the label.
Do not shake the prefilled syringe.
Do not remove the gray needle cap from the prefilled syringe until you are ready to inject.
Do not use the prefilled syringe if the carton is open or damaged.
Do not use a prefilled syringe if it has been dropped on a hard surface. The prefilled syringe may be broken even if you cannot see the break. Use a new prefilled syringe.
Do not attempt to activate the needle safety guard prior to injection. Do not use the prefilled syringe if the needle safety guard has been activated. Use another prefilled syringe that has not been activated and is ready to use.
The gray needle cap on the prefilled syringe contains dry natural rubber (made from latex). Tell your healthcare provider if you are allergic to latex. You should not give Armlupeg using the prefilled syringe if you have latex allergies.
Call your healthcare provider if you have any questions.
STEP 1: Prepare
A. Remove the prefilled syringe carton from refrigerator.
Check the expiration date printed on the carton.
Important: Do not use if the expiration date has passed.
Remove the syringe tray from the carton. On a clean, well-lit surface, place the syringe tray at room temperature for 30 minutes before you give an injection.
Do not remove the prefilled syringe from the original carton until you are ready to inject.
Do not use the prefilled syringe if the carton is damaged.
Do not try to warm the prefilled syringe by using a heat source such as hot water or microwave.
Do not leave the prefilled syringe in direct sunlight.
Do not shake the prefilled syringe.
Open the tray by peeling away the cover. Grab the safety guard to remove the prefilled syringe from the tray. (See Figure 3)
Ifu-figure-3 (25659536 Dc3c 46cd 9156 C462149428da 04)
For Safety reasons:
B. Inspect the medicine and prefilled syringe (See Figure 4).
Ifu-figure-4 (25659536 Dc3c 46cd 9156 C462149428da 05)
Make sure the medicine in prefilled syringe is clear and colorless (See Figure 4). It is normal to see one or more air bubbles in the syringe.
Do not use the prefilled syringe if:
The medicine is cloudy or discolored or contains flakes or particles.
Any part appears cracked or broken.
The prefilled syringe has been dropped.
The gray needle cap is missing or not securely attached.
The expiration date printed on the label has passed.
In all cases, use a new prefilled syringe and call your healthcare provider.
C. Gather all materials needed for injection (See Figure 5)
Wash your hands thoroughly with soap and water
On a clean, well-lit work surface, place the:
Prefilled syringe
Alcohol swab
Cotton ball or gauze pad
Adhesive bandage
Sharps disposal container
Ifu-figure-5 (25659536 Dc3c 46cd 9156 C462149428da 06)
STEP 2: Get ready
D. Select and clean the injection site (See Figures 6 and 7).
Ifu-figure-6 (25659536 Dc3c 46cd 9156 C462149428da 07)
You can use:
Clean the injection site with an alcohol swab (See Figure 7). Let the skin dry.
Ifu-figure-7 (25659536 Dc3c 46cd 9156 C462149428da 08)
Do not touch this area again before injecting.
If you want to use the same injection site, make sure it is not the same spot on the injection site you used for a previous injection.
Do not inject into areas where the skin is tender, bruised, red, or hard. Avoid injecting into areas with scars or stretch marks.
E. Hold the prefilled syringe by the syringe body. Carefully pull the gray needle cap straight off and away from the body (See Figure 8).
Ifu-figure-8 (25659536 Dc3c 46cd 9156 C462149428da 09)
Do not remove the gray needle cap from the prefilled syringe until you are ready to inject.
Do not twist or bend the needle cap.
Do not hold the prefilled syringe by the plunger rod
Do not put the gray needle cap back onto the syringe or never recap. If the needle cap is removed accidently and you are not ready for the injection, discard (throw away) the opened syringe and use a new syringe when ready.
Important: Throw the gray needle cap into the sharps disposal container (See Figure 9).
Ifu-figure-9 (25659536 Dc3c 46cd 9156 C462149428da 10)
Step 3: Subcutaneous (under the skin) injection
F. Point the needle up and gently tap the syringe body with your fingers until the air bubble rises to the top of the syringe (See Figure 10).
Ifu-figure-10 (25659536 Dc3c 46cd 9156 C462149428da 11)
G. Pinch the injection site to create a firm surface (See Figure 11).
Ifu-figure-11 (25659536 Dc3c 46cd 9156 C462149428da 12)
Important: Keep skin pinched while injecting
H. Hold the pinch. Insert the needle into the skin at 45 to 90 degrees. (See Figure 12)
Do not touch the plunger rod or grasp the syringe above the finger grips.
Ifu-figure-12 (25659536 Dc3c 46cd 9156 C462149428da 13)
I. Using slow and constant pressure, push the plunger head until it reaches the bottom. (See Figure 13)
Ifu-figure-13 (25659536 Dc3c 46cd 9156 C462149428da 14)
While the needle is still inserted in the skin, slowly move your thumb back, allowing the plunger rod to rise. This will release the needle safety guard to safely cover the needle. Then remove the syringe from the injection site. (See Figure 14)
Ifu-figure-14 (25659536 Dc3c 46cd 9156 C462149428da 15)
Important: When you remove the syringe, if it looks like the needle safety guard is not activated or some medicine is still left in the syringe, this means you have not received a full dose. Call your healthcare provider right away.
Step 4: Finish
Beforeyoufinish (25659536 Dc3c 46cd 9156 C462149428da 16)
J. For your safety, make sure that the needle safety guard is activated and fully covers the needle.
Once the needle safety guard is extended, it will lock into position and will not slide back over the needle.
Important: Keep your hands away from the needle at all times.
K. Discard (throw away) the used prefilled syringe.
Ifu-figure-15 (25659536 Dc3c 46cd 9156 C462149428da 17)
Put the used prefilled syringe into an FDA-cleared sharps disposal container right away after use (See Figure 15). Do not throw away (dispose of) the syringe in the household trash.
If you do not have an FDA-cleared sharps disposal container, you may use a household container that is:
o made of a heavy-duty plastic,
o can be closed with a tight-fitting, puncture-resistant lid, without sharps being able to come out,
o upright and stable during use,
o leak-resistant, and
o properly labeled to warn of hazardous waste inside the container.
When your sharps disposal container is almost full, you will need to follow your community guidelines for the right way to dispose of your sharps disposal container. There may be state or local laws about how you should throw away used needles and syringes. For more information about safe sharps disposal, and for specific information about sharps disposal in the state that you live in, go to the FDA's website at: http://www.fda.gov/safesharpsdisposal.
Do not reuse the prefilled syringe.
Do not recycle prefilled syringes or sharps disposal container or throw them into household trash.
Important: Always keep the sharps disposal container out of the reach of children.
L. Examine the injection site.
If there is blood, press a cotton ball or gauze pad on the injection site. Do not rub the injection site. Apply an adhesive bandage if needed.
This Instructions for Use has been approved by the U.S. Food and Drug Administration.
Manufactured for:
Lupin Pharmaceuticals, Inc.
Naples, FL 34108 United States.
Manufactured by:
Lupin Limited (Biotech Division)
Gat No. 1156, 1157, 1158, 1159 and 1160,
Village-Ghotawade, Taluka-Mulshi,
Pune – 412115, Maharashtra, India
Distributed by:
Valorum Biologics, LLC
555 Madison Ave. Suite 11D
New York, NY USA 10022
U.S. License No. 2052
Approved: November 2025