FDA Label for Electrum Numb Foam
View Indications, Usage & Precautions
Electrum Numb Foam Product Label
The following document was submitted to the FDA by the labeler of this product Renu Laboratories, Llc. The document includes published materials associated whith this product with the essential scientific information about this product as well as other prescribing information. Product labels may durg indications and usage, generic names, contraindications, active ingredients, strength dosage, routes of administration, appearance, warnings, inactive ingredients, etc.
Uses
can be used instead of soap and water to help clean minor cuts, scrapes, and burns.
- For the temporary relief of discomfort and pain associated with dermal procedures such as tattoo removal, tattoo, dermarolling, electrolysis, microblading and piercing.
- Temporarily relieves pain and itch while helping prevent infection
- Shake Well before each use. Apply 2 to 3 pumps of foam soap and gently rub into skin. Leave it on for 5 to 10 minutes. Rinse off gently with running water or wipe with a clean paper towel. Use before, during and after the procedure. Keep bottle tightened to keep product fresh and effective. Adults and children 2 years old and older. Use to clean minor cuts, scrapes and burns by thoroughly washing with water. Rinse and air dry. Use no more than 3 times a day.
- Children under two years of age, ask a doctor
Directions
Recent Major Changes
Directions for Use were added.
Warnings
For external use only
- avoid contact with eyes
- do not exceed recommended dosage unless directed by a doctor
Otc - Do Not Use
Do not use
- in the eyes or apply to large areas of body
- longer than 1 week unless directed by a doctor
- in large quantities particularly over raw surfaces or blistered areas
- ask a doctor before use if you have deep or puncture wounds, animal bites, or serious burns
Otc - Stop Use
Stop Use and ask a doctor if
- condition worsens or symptoms persist for more than 7 days or clear up and occur again within a few days.
Inactive Ingredient
Inactive Ingredients: Allantoin, Aloe Barbadensis (Aloe) Powder, Arnica Montana (Arnica) Extract, Caprylyl Glycol, Cocoamidopropyl Betaine, Deionized Water, Disdoium Cocoamphodiacetate, Glycerin, Hexylene Glycol, Phenoxyethanol, Sodium Chloride.
Otc - Keep Out Of Reach Of Children
Keep out of reach of children:
If swallowed, get medical help or contact a Poison Control Center right away.
Otc - Questions
Questions? 574-975-3632
Otc - Active Ingredient
Active Ingredient
Lidocaine HCL 4%
Benzethonium Chloride 0.25%
Otc - Purpose
Purpose
Topical anesthetic
First aid antiseptic
Statement Of Identity
ELECTRUM NUMB FOAM FOAMING ANESTHETIC
Dosage & Administration
Directions
Shake well before each use. Apply 2 to 3 pumps of foam soap and gently rub into skin. Leave it on for 5 to 10 minutes.
Rinse off gently with running water or wipe with a clean paper towel. Use before, during and after the procedure.
* Please review the disclaimer below.