FDA Label for Hand Sanitizer Wipes
View Indications, Usage & Precautions
Hand Sanitizer Wipes Product Label
The following document was submitted to the FDA by the labeler of this product Kync Design Llc. The document includes published materials associated whith this product with the essential scientific information about this product as well as other prescribing information. Product labels may durg indications and usage, generic names, contraindications, active ingredients, strength dosage, routes of administration, appearance, warnings, inactive ingredients, etc.
Other
SPL UNCLASSIFIED SECTION
Active Ingredient(S)
Benzalkonium Chloride 0.125% (CAS NO: 68424-85-1). Purpose: Antimicrobial
Purpose
Antimicrobial
Use
Hand sanitizing wipes help remove bacteria from hands and kill 99.99% of germs. Removes dirt to help with health and cleanliness.
Warnings
Use on hands only.
Do Not Use
Do not use if you are allergic to any of the ingeredients.
Do not use in or near the eyes. If contact occurs, rinse with plenty of water. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists, get medical advice/attention.
Otc - When Using
If swallowed, get medical help or contact a Poison Control Center immediately.
Otc - Stop Use
Stop use and ask a doctor if irritation or rash occurs.
Otc - Keep Out Of Reach Of Children
Keep out of reach of children.
Directions
To Open Package: Flip open dispensing cap. Locate wipe at center of roll and pull through small openning in lid. For best results dispense wipes at an angle. Wet hands thoroughly with product and allow to dry. When finished, snap lid cap shut to retain moisture. Discard wipe in trash receptacle after use. Do not flush.
Other Information
n/a
Inactive Ingredients
Water(Aqua), Ethanol, Decyl Glucoside, Glycerine, Aloe Vera Extract, D-Panthenol, Fragrance (Perfume)
Package Label - Principal Display Panel
110 mL NDC: 76557-001-01
245 mL NDC: 76557-001-01
* Please review the disclaimer below.