Drug Facts: Active Ingredients
Mentha Piperita Menthol Arial Parts 10%
Eucalyptus Globulus Eucalyptus Oil Leaf Oil 5%
Dona
FDA Label NDC 83658-009
Full FDA labeling including Indications, Dosage, Usage, and Precautions
Structured Product Label
The following Structured Product Label (SPL) was submitted to the FDA by Sj Incorporation Ltd for the product Dona (NDC 83658-009). This document serves as the official prescribing information, containing essential scientific data and clinical materials required for healthcare providers and patients.
This specific version of the label includes detailed information regarding drug facts: active ingredients, other ingredients:, uses:, idications & usuage, warnings: for external use only, keep out of sight and reach of children, directions:, package label.principal display panel, and other regulatory disclosures. Use the navigation below to review specific sections of the FDA submission.
Label Section Quick Index
Other Ingredients:
Adhesive (Tracaganth Gum Rasin Ester, Guar Gum Rosin Ester)* Naturally derived
Uses:
Temporarily relieves minor aches and pains of muscles and joints due to simple back ache, arthritis, strains, and sprains.
Idications & Usuage
Discreet and Comfortables
Warnings: For External Use Only
Disclaimer: This product is not intended to diagnose and/or prevent any ailment or disease.
- Single use only
- Product patches have not been tested on animals
- Store below 25 °C in a dry place, out of sight and reach of children
- Do not freeze
- Not recommended for use during pregnancy or for those planning a pregnancy
- Do not apply to broken, irritated skin or near to eyes
- Do not use if you have eczema or other skin problems
- In case of irritation or rash stop using the patch immediately.
If problem persists consult your GP.
Keep Out Of Sight And Reach Of Children
Directions:
- Dry skin before use. Cut open the foil sachet, remove a patch and peel off the protective paper from the central cut. Tip: Be careful when peeling the protective paper as the patch can stick to itself.
- Apply adhesive side of the patch where you want the cooling effect.
- Remove gently using warm water to loosen the adhesive. Discard and replace with a new patch as required.
Package Label.Principal Display Panel
* Please review the disclaimer below.
