FDA Label for Wart Remover
View Indications, Usage & Precautions
Wart Remover Product Label
The following document was submitted to the FDA by the labeler of this product Shanghai Jiujiurong E-commerce Trading Co., Ltd. The document includes published materials associated whith this product with the essential scientific information about this product as well as other prescribing information. Product labels may durg indications and usage, generic names, contraindications, active ingredients, strength dosage, routes of administration, appearance, warnings, inactive ingredients, etc.
Active Ingredient(S)
SALICYLIC ACID 1%
CHLORHEXIDINE 1%
Purpose
Wart Remover
Use
* For the removal of genital warts, plantar warts and flat warts, as well as common warts
* Plantar warts are easily identified because they are located only on the soles of the feet,
are painful to the touch, and have intermittent footprints.
* Location of flat warts: face, back of hands, forearms, etc. Appearance: flat, smooth, flesh-colored or light brown.
Feeling usually painless, but may feel mild discomfort
* Common warts are easily identified by their rough, " cauliflower-like”surface.
Warnings
For external use only-Avoid contact with eyes.
Do Not Use
*On inflamed or infected skin, or on red areas.
*If you have diabetes or poor circulation.
*On birthmarks, warts or moles with hair growth.
Otc - When Using
When using this product keep out of eyes, ears, and mouth. In case of contact
with eyes, rinse eyes thoroughly with water.
Otc - Stop Use
Stop use and ask a doctor
*If discomfort persists.
*If you have diabetes or poor circulation.
Keep out of reach of children. If swallowed, get medical help or contact a Poison Control C enter
(1-800-222- 1222) right away.
Otc - Keep Out Of Reach Of Children
*Keep out of reach of children. If swallowed, seek medical attention immediately.
*Avoid inhaling steam. Close the tube tightly.
*Avoid direct sunlight and store at room temperature away from heat sources.
Directions
1. Wash the affected area.
2. Soak the wart in warm water for 5 minutes.
3. Dry the affected area thoroughly with the applicator (cotton swab).
4. Apply a layer of ointment to each wart. Cover each wart thoroughly. Allow to dry and absorb completely, then bandage as needed.
5. Repeat this step once or twice daily (until the wart is gone) for up to 12 weeks.
Other Information
Avoid direct sunlight and store at room temperature away from heat sources.
Inactive Ingredients
AQUA, GLYCERIN, MINERAL OIL, GLYCERYL STEARATE,
TRIETHANOL-AMINE, CARBOMER
Package Label - Principal Display Panel
* Please review the disclaimer below.
