Teruflex Blood Bag System With Diversion Blood Sampling Arm Anticoagulant Citrate Phosphate Dextrose (cpd) And Optisol (as-5) Red Cell Preservative
Product Images NDC 53877-008

Product Visual Gallery

This gallery contains 8 technical images submitted to the FDA as part of the official labeling for Teruflex Blood Bag System With Diversion Blood Sampling Arm Anticoagulant Citrate Phosphate Dextrose (cpd) And Optisol (as-5) Red Cell Preservative (NDC 53877-008). Unlike standard consumer photos, these assets often include clinical data figures, molecular chemical structures, and official manufacturer packaging layouts.

As provided by Terumo Corporation, these visuals offer a comprehensive scientific overview of the product's physical and chemical identity, aiding pharmacists and researchers in product verification and study.

FDA Label Image

Image Of Representative Tray/case Label Cpd-opt 500ml With Dbsa (Mm13)

Label text from TERUFLEX Blood Bag System with Diversion Blood Sampling Arm by Terumo Corporation. It details composition of anticoagulant CPD and OPTISOL red cell preservative solution for 500 mL blood collection, including specific ingredient amounts. Instructions include storage conditions, donor needle size, and usage warnings.*

FDA Label Image

Fig. 1, Fig. 2a, Fig. 2b (Optisol 01)

An instructional diagram illustrating components of the TERUFLEX Blood Bag System with Diversion Blood Sampling Arm. It shows a female luer port with a port cap and clamp attached to a diversion pouch, notched for identification, connected to a CLIKTIP device. Another section depicts a blood bag with a clamp, female luer port, and male luer adapter, detailing blood flow connections.*

FDA Label Image

Fig. 3a, Fig. 3b (Optisol 02)

Illustrative diagram showing two configurations of a blood collection system labeled Fig. 3a and Fig. 3b. Fig. 3a depicts a bag with a notch, while Fig. 3b highlights a bag with a Cliktip, 'Y' connector, permanent seal, and a blood collection tube at the bottom.*

FDA Label Image

Figure (Optisol 03)

An instructional illustration showing a three-step process to seal a container. The first panel depicts folding one corner of a film or tape over the container edge, measuring approximately one fifth of its length. The second panel shows sealing the container with tape wrapped over its top. The third panel presents the fully sealed container with the tape securely attached.*

FDA Label Image

Figure (Optisol 04)

An illustration showing a component of the TERUFLEX Blood Bag System, specifically the diversion blood sampling arm device. The image highlights the device's connector and tubing, designed for blood collection and sampling within the system.*

FDA Label Image

Figure (Optisol 05)

Illustration showing a close-up view of the connection of a component, likely part of a blood collection or sampling system, secured with a strap. The image focuses on a segment of tubing with a connector or valve, consistent with components used in TERUFLEX Blood Bag Systems.*

FDA Label Image

Figure (Optisol 06)

An instructional line drawing showing two hands manipulating a blood sampling device. One hand holds the device steady while the other hand pulls a protective cover or sheath in the indicated direction, as shown by an arrow. This appears to demonstrate proper handling or preparation of the blood sampling arm component of the TERUFLEX Blood Bag System.*

FDA Label Image

Figure (Optisol 07)

An instructional line drawing showing a hand holding and pressing a clamp or slide mechanism on tubing, likely part of a blood bag system. The image focuses on the operation of the tubing control component.*

* About these descriptions: Image descriptions on this page are generated by automated AI analysis of the product label images from the manufacturer's FDA label submission (SPL). They are provided for reference only and may contain errors or omissions. Always rely on the printed label itself and the official FDA labeling, and consult a pharmacist or healthcare professional with any questions about this product.